发表评论取消回复
相关阅读
相关 [C盘分区以后 隐藏盘找不到怎么办?]
目录 前言: 使用方法: 示图: -------------------- 前言: 群里小伙伴找不到隐藏的分盘,然后咨询公司带他的人,那个人居然给了他一堆书,
相关 bga焊盘怎么做_FPC焊盘设计的最关键点
![280d4276a64a3763114acbd5e04613eb.png][] FPC,柔性电路板。一根FPC的电路数量可以超过100根,但只占据了0.2mm的厚度。虽然
相关 PE盘PE系统盘制作
一、首先找来一个8G以上的U盘,右键点击 格式化 ![在这里插入图片描述][watermark_type_ZmFuZ3poZW5naGVpdGk_shadow_10_tex
相关 PCB设计中焊盘的种类
关注+星标公众号,不错过精彩内容 ![aHR0cHM6Ly9pbWctYmxvZy5jc2RuaW1nLmNuL2ltZ19jb252ZXJ0L2Q4Njk1OGM5MWMw
相关 PCB_IPC7085中关于BGA引脚焊盘直径与引脚间距的关系
经常使用BGA元件,给自己写一个备注吧。 注:land, 有的文献翻译成焊盘,不过pad也被翻译成焊盘,下面要讲的是指引脚铜皮大小,不涉及PCB中的各个mask。 BGA的
相关 封装库设计3-焊盘绘制
100 mil =2.54 mm 0805封装电容 长0.5+/-0.2 宽1.25+/-0.2 引脚尺寸 1、焊盘要比引脚长0.3mm以上(begin lay
相关 cadence 17.2使用padstack editer制作完焊盘后在pcb editer中找不到焊盘
解决方法: 在pcb editer中选择setup - user perference 在左边一大堆文件夹中选择Paths-library,在padpath和psmpath
相关 allegro PCB Editer导出配置和导入配置
allegro PCB Editer使用的时候不会自动保存当前的设置,每次打开都要重新设置网格间距和各种颜色,现在可以通过导出配置来保存配置了。 导出配置:File -Exp
相关 通孔焊盘元件制作
第一步 Setup -Design Parameters,选择Design标签,user units设置为Millimeter,Accuracy设置为4 并且根据自己的焊盘设
相关 FRM 6ix edition Handbook网盘分享
分享的都是自己在找的过程中比较难找的,找到以后来分析给大家 这次分享个FRM handbook,只找到第六版,2016年的,应该是最新版本了? 老规矩,关注个人微信公众号雪
还没有评论,来说两句吧...