Linux下Redis安装与 SpringBoot连接redis

布满荆棘的人生 2022-05-24 04:06 248阅读 0赞

Linux安装redis步骤  
  
  
1 下载tar包  
2 解压tar文件 tar -xvf redis....  
3 编译源码 make  
4 make install 运行后每次不用定位到安装目录  
5 服务端启动 src/redis-server 或 redis-server  
6 客户端启动 src/redis-cli 或 redis-cli  
  
spring-boot连接redis时提示redis受保护和密码验证解决办法：  
  
链接redis 时只能通过本地localhost (127.0.0.1）这个来链接，而不能用网络ip(192.168..)这个链接，问题然如果用网络ip 链接会报以下的错误：  
  
(error) DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the lookback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the --portected-mode no option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.  
  
是说处于保护模式，只能本地链接，我们需要修改配置文件../redis.conf  
1)打开配置文件把下面对应的注释掉  
  
\# bind 127.0.0.1  
  
2)Redis默认不是以守护进程的方式运行，可以通过该配置项修改，使用yes启用守护进程，设置为no  
  
daemonize no  
  
3)保护模式  
  
protected-mode no  
  
4)最后关键的是：  
没反应应该是你启动服务端的时候没有带上配置文件。你可以./redis-server redis.conf  
你配置好了，但要重新启动redis,如果还是报一样的错误，很可能是没有启动到配置文件，所以需要真正的和配置文件启动需要：  
在redis.conf文件的当前目录下：  
  
$ redis-server redis.conf  
  
如果还是所某个端口已在使用，那么可能是有 后台程序在占用该端口，需要kill 掉该程序(kill -9 port)，重新带上配置文件。./redis-server redis.conf启动。