gitlab安装与配置(Centos6.8)

电玩女神 2022-03-30 08:42 441阅读 0赞

#### 0、Centos7请参照官方文档 ####

[https://about.gitlab.com/installation/\#centos-7][https_about.gitlab.com_installation_centos-7]

#### 1. Install and configure the necessary dependencies ####

下面命令可在gitlab官网找到，【Select an operating system...】选择不同的系统即可查看。

sudo yum install curl openssh-server openssh-clients postfix cronie
    
    # 先修改下面的配置文件再执行启动命令
    sudo service postfix start
    sudo chkconfig postfix on
    
    # 若不执行安装有可能遇到这个错误【lokkit: command not found 】
    yum -y install lokkit
    sudo lokkit -s http -s ssh

这里安装了postfix，我自行配置了postfix。

vim /etc/postfix/main.cf
    myhostname = sample.test.com　 ← 设置系统的主机名
    
    mydomain = test.com　 ← 设置域名（我们将让此处设置将成为E-mail地址“@”后面的部分）
    
    myorigin = $mydomain　 ← 将发信地址“@”后面的部分设置为域名（非系统主机名）
    
    inet_interfaces = all　 ← 接受来自所有网络的请求
    
    mydestination = $myhostname, localhost.$mydomain, localhost, $mydomain　 ← 指定发给本地邮件的域名
    
    home_mailbox = Maildir/　 ← 指定用户邮箱目录

然后测试邮件

echo "Mail Content" | mail -s "Mail Subject" xxxx@xxx.com

若出现【-bash: mail: command not found】执行如下命令：

yum -y install mailx

Note:if you see below warings after you run above command.

send-mail: warning: inet_protocols: IPv6 support is disabled: Address family not supported by protocol
    send-mail: warning: inet_protocols: configuring for IPv4 support only
    postdrop: warning: inet_protocols: IPv6 support is disabled: Address family not supported by protocol
    postdrop: warning: inet_protocols: configuring for IPv4 support only

that means you don't have IPv6 configured in your OS's network stack, but your mailer (presumably postfix) is configured to use IPv6. Since there is no IPv6 for your mailer to use, it's warning you that it's only going to use IPv4.

To disable the waring messsage, Go to `/etc/postfix/main.cf` and change from:

inet_protocols = all

to:

inet_protocols = ipv4

This will only use ipv4 and the warning message will go away.

You will have to issue a stop and start for postfix to register the change.

service postfix restart

查看log，确认邮件发送状态

Postfix邮件的log位置是：**/var/log/maillog**

发送成功的话，会返回250和OK，也可以去自己的邮件客户端查收。

一切OK的话，那Postfix mail service应该就搭建成功了。

查看邮件队列